Lock does not respond – door is open and accessible.

Press each keypad button for response when pressed.

Check batteries are installed and oriented correctly (polarity) in the battery case.

Check batteries are in good condition; replace batteries* if discharged.

Check to see if cable is fully connected and not pinched.

Lock does not respond – door is locked and inaccessible.

Batteries may be completely discharged.

Use key to gain entry and replace batteries*.

Unit chimes to indicate code acceptance, but the door will not open.

Check to see if there is another locking device on the door.

Check the door gaps for any foreign objects between door and frame.

Check that the cable is firmly connected to the PC board.

Unit chimes to indicate code acceptance, but the door will not open.

Check the door gaps for any foreign objects between door and frame.

Check that the wire harness is firmly connected to the PCB.

Unit operates to allow access, but will not automatically re-lock.

Check to see if Auto Re-lock Mode is enabled.

Disable Auto Re-lock Mode to lock the door (automatically).

If low battery indicator is lit (see below), change batteries *.

PIN codes will not register.

PIN codes must consist of 4 to 8 digits to register.

The same code cannot be used for multiple users.

Registration/management of codes is set by the PIN authority of the Master Code, which is set first.

Contact the Master user.

User codes must be entered within 5 seconds (while touchscreen is active) or the process will have to be restarted.

Check or gear keys cannot be used as part of the code.

Upon entering a code PIN and pressing key, the unit displays " invalid code" error or lock times out without responding.

Lockout Mode is enabled

Only the Master can enable/disable Lockout Mode.

Contact the Master user.

Upon entering a code PIN and pressing the key, the red padlock icon appears and there are different tones.

Check to see if the lock is set to All Code Lockout Mode.

Setting/managing All Code Lockout Mode is done through Master Code only. Contact the Master user

The unit operates, but it makes no sound.

Enable Audio Mode.

The unit displays intermittent RED flashes.

This is the Low Battery indicator alerting that it is time to replace the batteries. Replace all four (4) batteries* with new AA Alkaline batteries.

Upon entering a PIN code and pressing the checkmark key, the unit responds with a series of beeps and the keypad flashes three times.

The digits entered were incorrect or incomplete. Re-enter the correct code followed by the check mark key.