Enable HomeKit Compatibility for Your Yale Assure Lock. Control your Yale Assure Lock from your iPhone, iPad or iPod Touch by integrating it into your Apple HomeKit system with the Apple iM1 HomeKit Module (lock sold separately).

This simple add-on module plugs into the lock in the same compartment as the batteries. By enabling HomeKit compatibility, it provides compatibility with Apple's Home app, adding smart, wireless capabilities for your lock, such as locking/unlocking via the Home App on your iOS device, commanding the lock by talking to Siri, or managing the lock through your Apple TV.

Before You Get Started

The Yale iM1 Network Module requires a compatible Yale Assure Lock (YRD256 or YRD246) and an iPhone, iPad or iPod touch with iOS 10.3 or later.

An Apple TV®, with tvOS 10.2 or later or an iPad® with iOS 10.3 or later set up as a home hub in order to operate HomeKit-enabled accessories remotely.

Works with the Yale Secure app, available in the U.S. and Canada only.

What You Need

The following is a list of everything you need to begin installing the module. Verify that all of these parts were included in the packaging:

• Yale iM1 Module

You will also need:

• A small Phillips head screwdriver to remove the battery cover from your Assure Lock

Installation Steps

Installing the Yale iM1 Network Module

IMPORTANT: the batteries must be removed prior to removing and/or inserting the network module:

1. Remove battery cover and batteries.
2. Remove and/or insert Network Module.
3. Reinstall batteries and battery cover.

Enrolling the iM1 Network Module:

The Yale iM1 Network Module must be used with a Yale Assure Lock or Yale nexTouch Lock and cannot be used in conjunction with any other Yale Network Module. To Enroll the Module:

1. Enter the 4-8 digit Master PIN code followed by the [gear] key.
2. Press the “7” key followed by the [gear] key.
3. Press the “1” key followed by the [gear] key.

In App Setup

Connecting the Yale Secure App with the Yale iM1 Network Module:

1. After following steps listed on other side of page for enrolling module, download the Yale Secure app from App Store®.
2. Ensure Bluetooth® is enabled on your iPhone®, iPad® or iPod touch®, and that you're within a foot of your Yale lock.
3. Open the Yale Secure app and agree to allow app to access your Home Data.
4. If you do not have a home already created, create a new home when prompted. Tap + to add a new Yale Lock.
5. The App will search for your Yale Lock. Be sure that you are within close proximity (less than two feet or so). When "Yale Lock" appears, tap to add.
   • If lock does not appear, enter your Master Pin Code on lock keypad, tap gear, tap 7, tap gear, tap 1 and then tap gear.
6. Scan your Accessory Setup Code; shown below, or manually enter within the app.